Pool Demolition Dumpster Rental in Concord, California
Short answer: pool demolition debris in Concord typically needs one to three flat rate containers for concrete, at $550 each with no weight limit, plus a standard container from $765 for anything mixed. A mid-size inground pool produces 20 to 30 tons of concrete, which is why the flat rate exists.
Pool removal is the single job on our site where the weight math is the most dramatic. A 15 by 30 foot pool shell, broken up with the rebar still inside, commonly weighs 20 to 30 tons. In a standard container billed by weight, that overage alone would run into the thousands. In the flat rate container, it is $550 per load, full stop.
Concrete Weight by Pool Size
The number of flat rate containers a job needs scales with the pool’s footprint, not with how the job is priced overall. Here is the range we see across the sizes that come up most often.
Estimated concrete weight and container count by pool size
| Pool size | Concrete weight | Containers needed | Concrete cost range | Note |
| Small (10×20 ft, above/inground) | 6-9 tons |
1 flat rate container | $550 | Coping and small decking add ~1 ton |
| Medium (15×30 ft, standard inground) | 20-30 tons |
1-2 flat rate containers | $550-$1,100 | Typical suburban pool |
| Large (20×40 ft or freeform) | 35-50 tons |
2-3 flat rate containers | $1,100-$1,650 | Common with attached spa or large decking |
| Any size, cap and fill | 40-60% of full removal weight |
Usually 1 container | $550-$800 | Top portion only, less rebar exposed |
These are estimates based on standard gunite and shotcrete construction. A pool with an unusually thick shell, a raised spa, or extensive decking can run heavier than its footprint suggests, which is why we confirm the container count from the actual dimensions rather than the table alone.
Why Two Containers, Not One
- Concrete and clean fill both qualify for flat rate pricing because they go to a recycling facility rather than a landfill.
- Wood decking, fencing, equipment housings and plaster mixed with debris do not qualify and need a standard 30 or 40 yard instead.
- Keeping the two streams apart from the start of the job, not sorting a mixed pile afterward, is what makes the flat rate hold.
Rebar Does Not Change the Price
Steel rebar left inside broken pool shell concrete is fine for the flat rate container, the same as it is for a driveway slab; the recycling facility separates it magnetically once the concrete is crushed. What does not qualify is anything the demolition crew leaves mixed in on purpose to save a trip, like coping stones with attached tile or plaster still bonded to fencing hardware, since sorting that at the facility gate reclassifies the whole load.
Full Excavation vs. Cap and Fill
A full removal takes the entire shell out and either backfills the hole or leaves it for new construction. A cap and fill removal breaks only the top portion of the walls and caps the pool below grade, producing roughly 40 to 60 percent of the concrete weight of a full removal. Permit requirements for pool demolition are set locally; the California Contractors State License Board maintains licensing standards for demolition contractors if you are hiring one for the excavation itself.
Booking
Call (925) 940-9906 or use the contact page with the pool dimensions and whether it is a full or partial removal. Compare every container on the dumpster sizes page, or see the rest of what we haul on the services page.
RP
Rafael Pires, OwnerWeight figures based on concrete and fill hauled from Bay Area pool demolitions. Last reviewed August 2026.